i know what the 1700.1 can do but what about the 1600.1...my boy has the 1600.1 on 4 sa8s and its not cutting it...would the 1700.1 be a better amp then the 1600.1...i dont really know much about mmats...
No, i do think the brz2100 or brz2400 will make those 8s wang
Jeep Grand Cherokee
Head - 7" soundstream 732
Front & Rear Speakers - Sony 6.5 4 ways & 2 sets of titanium tweets
Subs - (2) D2 12in obsidian audio To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
MMATS was the first company to do 1000 rms in less than 12" of sink. Or 1200, something like that. Correct me if I'm wrong, but I think they spear-headed Class-D technology also. Handmade in Florida.
I know the older ones from the 90's did the do, but I don't have a clue about the newer line-up.
This is when amps like theirs were somewhat shunned because they were so dang small compared to the comp. like Orion, Soundstream, PPI, Hifonics. So alot of folks were leery about an amp that claimed 1000 rms but wasn't 3 feet long.
But for awhile they were doing some serious damage to the established sect's reputations. They were winning comps everywhere and guys were like, "where in the heck did these guys come from".
The older ones didn't have a subsonic filter, but could be modded at your own risk to put out even more power.
Something's off, possibly with the enclosure or something out of phase. I have once in my life seen a sub that was labeled backwards (actually the red paint dot was on the wrong side so it was probably a human error at the factory). If you for sure checked everything and it still doesn't sound right it's probably his enclosure.
How are the subs aiming and where is the port firing? Also you can't really just play subs and tell if one is out of phase, touching a 9 volt battery to the terminal is a good way to do a quick check polarity. It's DC so the sub will move in, or out depending on which way you hook it up.
this seems quite obvious to me ... if you are gainset to 1150 then after rise you are probably right around 600 for 4 subs. thats 150 per sub and thats nothing for sa's... They need a bit more power than that to get going. So yes a brz1700 would be a big difference but a 2400 would be a very large difference. Correct me if I am wrong... Also what are you gainset to? What db tone did you use?
3 HDD 18s, 18 ish cubes, daily tuned to 31hz
AB 500.1 soon to be Tantric 4.1
Ohio Gen 300 amp alt
SKBT100.. (might be replaced with NSB90)
97 Tahoe LT
diymobileaudio.com is the DIY car audio install forum for automotive quality and spl stereo bass. 12 volt audio installation wholesalers buy amps, subs, double din car audio head unit electronics and ipod blue tooth car alarms at discounted prices