Wrapper

[07blackg5]

I cant physically fit the width of an 8" behind the seat. I only have 7.5" of available depth. even if I angled the top of the box a touch, it would put the magnet into the back of the box. Using 1/2" mdf would get me on the higher side for net volume, but still not enough for 2 drivers.

Here is a picture. The black "shelf" is 7" deep. I put an old home theater sub I have in to test for clearance (7.5"deep x 7"high) and squeezing the seat against it puts me right at the edge of comfort. I figure with the 6.5 height, I might get lucky and get one more click back on the slider.

I could use aero ports up against the back of the cab, but the seat tapers fast, and I'm not sure I would have much useable height. In the current position (with the 7.5d x 6.5h clearance), the seat back to cab clearance is less than an inch just below the glass. And that is pushing it in terms of my clearance. Normally the seats are pressed against the back.

The whole bench is slid forward a tad from my driving position. not a whole lot of space here


I wanted to remove the jack, but there is a big stamped frame welded to the cab that I would rather not cut out, so Im stuck with the 35.5" width with the plastic cover off.
Edit: With the lasts sentence being said, I can only really have the sub and port up as the sides will be flush, and the seat presses against the front of the box.