sexy truck.... not fond of trucks unless they are done right
-18" BTL fully loaded
-1 sets of RF power coax's
-1 set infinity refrence comps
-pushing mids and tweets with GP4150
-1/0 AWG wire (MTX and Knu)
-optima yellowtop and Northstar NSB 125
-Stock 120A(or 150 or soemthing) Alt
It was a little dirty, been sitting in my cousins shed for about a year now, but still in good shape.
Me, him, and a buddy of mine built it about a year and a half ago for 2 15s, it worked good until he blew them...hah.
Not sure of the specs, i'll measure the airspace later on, i think it was about 8-9 cubes...all i can remember is that we tuned it to like 31ish. Hits lowww.
Theres a good bit of work to be done...new front piece, a lot of unnecessary drilled holes that have to be filled, 1 or 2 air leaks, and I'll probably round over the edges just for looks. The hole in the back was for his extra battery...I won't be using one unless plans change. But overall, it's a solid box, just needs some attention to detail.
Also, sold the crunch today. Looking for a ZX1500.1 because I need to run these at 2ohms, and it should give me just the right amount of Power because it's a big ass box, no need to overpower CVRs here.
Some interior shots...it's pretty simple...haven't really decided what i'm gonna do to it yet.
Got the piece off.
Did a little sanding, I'm gonna have to go borrow my grandpas sander to finish it up...hand sanding ftl.
BTW, I figured out the specs on the box. exactly 8 cubes with all displacements, tuned at 31.44 hz with 91 sq. inches of port space.
yay. box is done, just gotta cut the holes, finish sanding a bit, and figure out how i'm gonna cover it. been thinking about spray can bedliner, something simple and durable. but im open to suggestions...
im running 2 cvr tunned to 32 hertz.... in abour 4 cubes... sounds like it is a high 30 low 40s.... so they are nice... should be in the mid 40 range with for .. how much power u gonna give them..??? what u gonna tune them too...?
NEW CAR IN THE WORKS.. POWERED BY SSA
The box is 8 cubes @ 31.44 hz...I'm not really worried about what it meters...just want it to perform good daily. They're gonna be powered with a Kicker 1500.1 since I have to run them @ 2ohm so selection is kinda limited. The birthsheets usually rate them at about 1700-1800ish...so about 400-450 watts to each. I don't want to take a chance of overpowering them, I've blown 2 CVRs before already..
diymobileaudio.com is the DIY car audio install forum for automotive quality and spl stereo bass. 12 volt audio installation wholesalers buy amps, subs, double din car audio head unit electronics and ipod blue tooth car alarms at discounted prices