I recently had my Car broke into and my subs,amp, and HU swooped. Its been about 2 months and i need my bass back. I have a few left over subs ( a 12" RE SE and a 12" MMATS procast) but want to put them in my room rather back into my car so i can get them stolen too. Whats is the cheapest and easyest way to do this? i dont know if this is in the right section but any help will be apperciated! thanks
Im dont think many plate amps are meant to run at 1ohm. You could run them at 8ohms though. Most likely you would be severely underpowering them, but you wont blow your amp. I would stick with one sub running at 2ohms if I were you...
'01 2door Blazer
Sub Build in Progress...
dam thats alot of power , i only want like 400 watts since i used to run the sub off about 240 RMS and it slamed realy hard. But ill look into the roe store, and if i ran the 2 subs couldnt i get 4ohms? since i can run them both down to 2 ohms then wire them together for either 1 or 4? or would running 2 diff subs off one plate amp hurt them?
diymobileaudio.com is the DIY car audio install forum for automotive quality and spl stereo bass. 12 volt audio installation wholesalers buy amps, subs, double din car audio head unit electronics and ipod blue tooth car alarms at discounted prices