It's my old kicker cvr12 dual 2 ohm voice coil sub, i want to blow it up just for kicks because i mite be getting some new ones. plus this sub is not the type i would want to sell because the tensel leads are all ripped off and i keep replacing them with some other kind of Wire and everytime the bass would get good the sub would just cut off and would just make me want to break the freakin thing!! grrr. lol
so should i just plug it in the wall socket already?
Soooo, when do we get to see that kicker meet mr. wall socket? I'm bored and can't sleep.
2001 Mustang GT
Pioneer Premier FH-P800BT head unit
powerbass 2XL6802's front and rear
old school Coustic Power Logic AMP268 four ch. mid/high amp
4 2010 Alpine Type R SWR1243D's, two facing up in .65 cu.ft. each sealed, the other two inverted to get .85 cu.ft. sealed each, I didn't have enough room to do all four that way.
Power Acoustik PS1-5500D taking a .5 ohm daily like a champ.
200 amp 6g alternator
big three with 2awg wiring
1 Stinger SPV70 up front, another one in the trunk
-18" BTL fully loaded
-1 sets of RF power coax's
-1 set infinity refrence comps
-pushing mids and tweets with GP4150
-1/0 AWG wire (MTX and Knu)
-optima yellowtop and Northstar NSB 125
-Stock 120A(or 150 or soemthing) Alt
diymobileaudio.com is the DIY car audio install forum for automotive quality and spl stereo bass. 12 volt audio installation wholesalers buy amps, subs, double din car audio head unit electronics and ipod blue tooth car alarms at discounted prices